Should I remove the entire subfloor or just the sections that don’t reach the wall when redoing my closet with tile flooring?
Asked by Roberto Masson 
2 months ago
Last Updated: October 13, 2024
Hey there! I’m new here. I’ve hit a bit of a roadblock on a project I started. I’m in the process of redoing my closet, which involves taking out the carpet. I’m planning on replacing it with tile, but the subfloor doesn’t extend all the way to the wall in certain spots. Should I remove the entire subfloor or just the sections that don’t reach the wall? Any tips would be super helpful. Thanks in advance!
Just fill any gaps between the tiles with thin set that are larger than the tile itself. ‘t worry about walking on the edge, and the baseboard will provide protection.
This seems like a secondary subfloor made up of different materials. If you’re planning to install tile, particularly large or plank tile, it’s important to understand why the second layer was put in and why small sections were used. Ceramic tile can be unforgiving, and a poor subfloor can ruin a good tile installation quickly.
Could you share a photo of the whole closet floor? The first 2 photos look different from the last 2. It would be useful to see the complete picture.
‘t be concerned about the sheet rock not reaching the floor entirely – the baseboard will cover that up. It’s always aesthetically pleasing when the floor levels in different rooms are consistent. To achieve this, you may need to add some material like plywood, cement board, or any other material suitable for your tile type. Make sure to choose the right thickness.
You didn’t mention the type of tile you’re using, which is important. However, go ahead and remove the existing tile. Using a heat gun can make this task much easier – just warm it up and it will peel off easily.
I think others may not be noticing the same things I am. It appears that you currently have 12” x 12” tile on the floor.
Simply place a baseboard after tiling and the space will vanish. If you prefer, you can also seal it with caulk.