How can I mount these angle shelves to appear floating while utilizing a bracket, considering the limited stud options available?
Asked by Oğuzhan Baykam 
3 months ago
Last Updated: September 20, 2024
Do you have any tips on how to install these angle shelves? I was hoping for a floating look, but I’m not opposed to using a bracket if needed. I found a stud along the blue tape line, and on the left side, there’s a 2×4 against another 2×4 in the wall that seems to be the only stud I can work with. Right now, my only plan is to use a backer board for them to sit on.
I would go with a personalized steel bracket featuring a 1/2″ rod inserted into the shelves. Make sure to drill the 1/2″ hole in the shelves. Cut through the drywall and securely attach the bracket to the studs in the corner. Then, slide the shelves onto the rods of the bracket.
I hadn’t considered cutting into the drywall. I actually kind of like that suggestion
You’ll need two brackets at an angle (bend or adjust them) so that the shelf can slide smoothly against the wall. Before attaching, fill the holes with construction adhesive to prevent any mess. Definitely do a test fit first!
No content
Has some brackets that need to be cut, drilled out, and bent to the correct angle you demonstrated. Then notch the wood appropriately for the bends to sleeve over and hide.
How about cutting this bracket in half and shaping them according to Aaron’s red drawing? Then you can either carve out the wood to conceal the bends or remove the drywall to properly secure them to the studs. The thickness of the mud/drywall would cover the bends. For larger shelves, it’s best to remove the drywall and mount them on the studs, even though these are small.
Hey , these are small brackets. I’ll cut and bend them as recommended. Thanks a lot 🙏
Another option would be to use French cleats. I have them installed on two of my triangle shelves that hold plants.
To give it an artsy look, attach the hidden floating bracket on the right side and add matching wood leg/pillar supports on the left and center. Even though it appears like it might tip over to the right, it’s actually secure.
I agree with the French cleat suggestion. Trying to bend the brackets, as others have mentioned, could be tricky and time-consuming to achieve consistent angles. Usually, corners have studs for anchoring. In case the shelf is too small to reach the stud, you can use reliable drywall anchors like these: 75-lb 1/2-in x 1-1/4-in Multi-Purpose Anchors with Screws Included (4-Pack) https://www.lowes.com/pd/E-Z-Ancor-4-Pack-Standard-Drywall-Anchor-Screws-Included/1098799
Will the shelves be positioned above or below the electrical outlet on the left side? I’m assuming they will be higher.
I decided to go with the French cleats for a neat appearance and easy setup. The corner is mainly for decorative items so the shelf won’t hold much weight. I made sure to leave openings in the back for power cords to pass through.
Those brackets could work. Just drill a wider slot instead of just a hole so they can slide on. I’ve also used a French cleat on a corner floating vanity. Just make sure to mill a recess to hide the cleat.
This is a French cleat mount
The easiest way to do it might be to drill two holes either on the front or bottom, then fill the holes with dowel rods after screwing them into the wall.
If you’re using them for heavy objects, consider steel rails or floating shelf fixings with steel rods.
The shelves look great! Did you make them from worktops?
Has some extra pieces from a butcher block
Have you considered using the metal corner brackets at this link?
https://cascadeironco.com/products/corner-shelf-bracket
For the back corner, prefers to keep it open for wires. Those were actually the first things I thought of 🙂
Metal angles
Floating shelf hardware can be found on Amazon