Has anyone dealt with a fabric headboard that’s too tall for windows in a master bedroom during a move? (See picture for context)
Asked by Sara Hakola 
2 months ago
Last Updated: November 7, 2024
Hey, quick question…
Has anyone ever shortened a fabric headboard before?
We’re moving and it’s too tall, blocking all the windows in the master bedroom, no matter how we rearrange things.
*Check out the picture for a better idea!*
I’m not entirely sure, but I would definitely trim it from the bottom
Could you trim the bottom so it’s less noticeable on top?
All you have to do is cut it to the desired length and make sure to leave 2 inches of material for overlapping
It should be pretty easy to accomplish
I actually haven’t cut from the bottom yet, so it shouldn’t be a problem
Is it possible to trim the legs and then connect them to the base at a higher point on the leg/side?
Take off the legs.
Shouldn’t be an issue, what I would do is undo the lower seam, roll the fabric upwards. Once you trim the bottom of the headboard, secure the fabric at the bottom with staples. Another option could be to position the headboard at the back of the base instead of placing it on top, that would bring it down a bit.
We have experience in shortening a headboard, and we approached it from the bottom.
Is intelligent
If you happen to be close to St. Louis, I can help you out for no charge. I actually have two similar ones that I created. I’m familiar with how they are assembled. Just begin at the end and remove the tacks or staples, then carefully peel back the fabric and padding. Trim down the support board to your desired height and tuck the stuffing and fabric back in. Secure it back in place with a stapler.
Sure thing! Would you like me to help you with the same text as before?
It might be simpler to just trim your ceiling instead.
…MAKE THE LEGS SHORTER….
I really like how it gives your wall the illusion of being taller
Sure thing, start by removing the legs and pulling back the fabric. Then, cut the wood to the correct size. Make sure to reposition the wood in the corners where the bedframe was attached for better support, and then redrill the holes. Finally, cut the fabric, restaple it, and reattach the legs.