Any suggestions on how to finish installing a bathtub in an unfinished basement bathroom with obstructive screws?
Asked by Frances Jennings 
3 months ago
Last Updated: August 30, 2024
I have a bathroom in my basement that I haven’t quite finished yet. I’m a bit stuck on how to complete the installation of the bathtub. It seems like these screws are causing some trouble. Any thoughts on how to wrap up this project?
That installation is good to go for tiling. Just remember to have the bottom row of tiles covering the screws.
Is mistaken. Drywall is not suitable for tiling.
Drywall is a great surface for tiling. Look it up, smarty pants.
You should definitely consider taking a Schluter class. And hey, since you’re Canadian, why not take it three times and kindly ask the instructor to speak extra slowly for you, eh?
Hey smartypants, just so you know, it’s common sense that you shouldn’t use that for showers and bathtubs. So, don’t try to come at me with insults when your advice is completely off base.
Said it’s okay to tile over green drywall.
I’ll make sure to verify that.
It’s pointless trying to reason with you, you’re just an ignorant fool who believes that nationality is important. Did you know that more Americans say ‘eh’ than Canadians do? So go educate yourself. But make sure to hear it repeated 3 or 4 times, as you seem like someone who thinks they know it all and will try to force their opinion on others due to their inflated ego. And even if you’re wrong, no one will challenge you. How ridiculous.
Can you please explain to me how to pass a Schluter class? I doubt you’re smart enough, genius. You simply bond Schluter Kerdi to the drywall using an unmodified thin set, then proceed with tiling. It’s not rocket science, even a Canadian should be able to figure that out.
Did I maybe use words that were too complex for you?
Hey , I believe it’s referred to as aqua board around here
Hey , I disagree with you. That’s why we’re discussing this. You’re completely mistaken.
Is definitely not wrong at all.
If you can’t understand this, then you probably shouldn’t mess with tile. 😂😂😂😂😂 Silly.
‘s aquaboard is different from what I’m referring to.
Drywall is okay for tiling, but not ideal for tubs/showers. It might work for just a tub, but it’s generally not recommended. Cement board or other options like Schlutter are better choices for tiling in wet areas.
Primed drywall can be tiled, but it’s not recommended for wet areas like tubs or showers.
Drywall can be used as a substrate for tiling, as long as it is waterproofed properly. Green board is just resistant to mold.
Absolutely, ! Tiling directly onto drywall is a viable option.
Seems to be drywall. It’s not supposed to go behind the tub, it should end just above the flange. This way, the tub would be set back by half an inch. Then the surrounding area would cover the screws and ensure it’s watertight as per the manufacturer’s design. Looks like someone skipped reading the instructions. It needs to be redone.
It seems like it actually requires the sidewall kit to cover it up. It’s not advisable to leave the sheetrock exposed near the tub. I always thought that’s what the side wall was for.
If you’re not opting for a direct install shower siding kit, you’ll have to replace the Sheetrock with water-resistant rock board or hardy board, typically in green or purple hues.
Your best bet for a budget-friendly and efficient solution would be to install thin direct glue shower side walls and seal them with caulk. It may not be perfect, but it will get the job done if you’re looking for something basic.
No content
We used water-resistant sheetrock over the shower wall ends and then covered it with plastic ends. We will mud and then caulk the seam between the surround and the edges.
Remove the washers, put the screws back in, and then finish it off with whatever you had in mind.